New Products

Taig extra tool post (same as supplied with lathe)

Taig ER16 Collet Set with 6 collet sizes 1/16, 1/8, 3/16, 1/4, 5/16, 3/8. These collets are for use with an ER16 spindle or Taig ER16 collet ... more info

Taig ER16 Collet Nut for ER16 collets. The ER16 collet nut is a critical component to the ER16 holding system. Damaged nuts must be ... more info

Taig Fly Cutter, 1 1/4 to 2 1/2 inch diameter with 3/8" shank used on ER16 spindle  Left hand tool bit included.

Taig ER 16 Adapter for 3/4-16 spindle. ER16 Nut included (Use ER16 collets in your 3/4-16 Spindle) This works well for using ER collets ... more info

Taig Drilling tailstock, lever operated 5/8" off set with dead center, 3/8-24 thd for drill chucks.

Taig Die holder for tailstock (will accept 13/16" and 1.00" button dies)

Depth stop for workpiece in lathe chuck. Inserts through spindle. Threaded rod can be used to set a consistant stop depth for parts being held in ... more info

Taig back tool post, tool bit mounts upside down in this holder, behind the work and cuts from the back side This is not the same as a front ... more info

Taig 6 step replacement pulley set (2 pulleys per set) 3/8" motor shaft. 3M500 belt included. NOTE: A new belt should ALWAYS be used with ... more info