Taig Accessories

Machine tool accesories produced primairly for Taig Tool mico-machines. Of couse they may be suitable for any other use.

Taig 4 jaw 3 1/4" dia. chuck
1030

Taig 4 jaw 3 1/4" dia. chuck

4 jaw 3 1/4" dia. chuck 3/4-16 thd mount jaws adjusted independently (reversable heat treated steel jaws
$65.07
Add:
Taig 4 Jaw 3 1/4" dia. self centering scroll chuck
1060

Taig 4 Jaw 3 1/4" dia. self centering scroll chuck

Taig 4 Jaw 3 1/4" dia. self centering scroll chuck (steel body) with aluminum soft jaws 3/4-16 thd. for the Taig Micro Lath II. This...
$70.29
... more info
 Sold Out 
Taig 5 Piece End Mill Set
1230

Taig 5 Piece End Mill Set

Taig 5 Piece End Mill Set (DOUBLE ended) 1/16,3/32,1/8,5/32,3/16 inch.
$48.06
Add:
Taig 6 piece high speed steel tool bit set
1095

Taig 6 piece high speed steel tool bit set

Taig 6 piece high speed steel tool bit set, left,right,45 degree,round nose,boring bar, and cut off
$29.79
Add:
Taig 6 step pulley set 1/2" motor shaft
1162

Taig 6 step pulley set 1/2" motor shaft

Taig 6 step replacement pulley set (2 pulleys per set) 1/2" motor shaft. 3M315 belt included. Optional 3M500 20" belt may be selected....
$27.23
... more info
Taig 6 step pulley set 3/8" motor shaft
1161

Taig 6 step pulley set 3/8" motor shaft

Taig 6 step replacement pulley set (2 pulleys per set) 3/8" motor shaft. 3M500 belt included. NOTE: A new belt should ALWAYS be used with...
$27.23
... more info
Taig Adjustable Boring Head
2035ER

Taig Adjustable Boring Head

Taig Adjustable Boring Head for use on the Mill. Allows you to bore holes from approx 3/8" to 1 1/2". Boring head has 3/8" shank....
$44.82
Add:
Taig Back Tool Post
1171

Taig Back Tool Post

Taig back tool post, tool bit mounts upside down in this holder, behind the work and cuts from the back side This is not the same as a front...
$5.49
Add:
Taig Die holder for tailstock
1152

Taig Die holder for tailstock

Taig Die holder for tailstock (will accept 13/16" and 1.00" button dies)
$16.11
Add:
Taig Drill chuck arbor (3/8-24 thread) with 3/8" shank
1140ER

Taig Drill chuck arbor (3/8-24 thread) with 3/8" shank

Taig Drill chuck arbor (3/8-24 thread) with 3/8" shank, attaches Jacobs chucks to ER headstock spindle using a 3/8" ER16 collet.
$10.49
Add:
Your IP Address is: 54.81.73.2
Copyright © 2017 Ramblin' Dan's Store. Powered by Zen Cart