Taig Accessories

Machine tool accesories produced primairly for Taig Tool mico-machines. Of couse they may be suitable for any other use.

Taig Unground tool bit 1/4" square
1096

Taig Unground tool bit 1/4" square

Taig Unground tool bit 1/4" square.
$2.30
Add:
Taig Standard Lathe Individual Collets
1041X

Taig Standard Lathe Individual Collets

Taig Standard Taper Collet 7 collet sizes 1/8,5/32,3/16,7/32,1/4,9/32,5/16. A set of four blank collets can be specified for making your own custom...
$3.45
... more info
Taig depth stop for workpiece in lathe chuck
1026

Taig depth stop for workpiece in lathe chuck

Depth stop for workpiece in lathe chuck. Inserts through spindle. Threaded rod can be used to set a consistant stop depth for parts being held in...
$3.60
Add:
Taig Extra Tool Post
1170

Taig Extra Tool Post

Taig extra tool post (same as supplied with lathe)
$4.59
Add:
Taig Back Tool Post
1171

Taig Back Tool Post

Taig back tool post, tool bit mounts upside down in this holder, behind the work and cuts from the back side This is not the same as a front...
$5.49
Add:
Taig High Speed Steel Tool Bit
1097X

Taig High Speed Steel Tool Bit

Taig  High Speed Steel (HSS) tool bit Left, right, 45 degree, round nose, boring bar, and cut off are available. Also available as a complete...
$6.25
... more info
Taig 1" SPINDLE WRENCH
1310

Taig 1" SPINDLE WRENCH

Taig 1" SPINDLE WRENCH. For use on the Taig Micro Lathe II. Very thin to fit spindle nut behind a chuck.
$7.50
Add:
3M315 Spare Gates polyurethane vee belt
1159

3M315 Spare Gates polyurethane vee belt

Taig 1159 - Spare Gates polyurethane vee belt (est. belt life 5000 hours) No.3M315 12 1/2" flat length
$8.87
Add:
3M500 Spare Gates polyurethane vee belt
1160

3M500 Spare Gates polyurethane vee belt

Taig 1160 - Spare Gates polyurethane vee belt (est. belt life 5000 hours) No.3M500 20" flat length
$8.87
Add:
Taig Drill chuck arbor (3/8-24 thread) with 3/8" shank
1140ER

Taig Drill chuck arbor (3/8-24 thread) with 3/8" shank

Taig Drill chuck arbor (3/8-24 thread) with 3/8" shank, attaches Jacobs chucks to ER headstock spindle using a 3/8" ER16 collet.
$10.49
Add:
Your IP Address is: 54.158.253.134
Copyright © 2017 Ramblin' Dan's Store. Powered by Zen Cart